How to install FGTECH galletto v54 on both XP and win7



Here are step-by-step procedure on how to install FGTECH galletto v54 on both XP and win7.

  1. Install sw to default place c:\fgtech
  1. Plug galletto v54 to usb port.
  1. Go to device manager and uninstall actual driver of fgtech.
  1. Unplug fgtech from usb and plug it again.
  1. Install drivers provided into c:\fgtech folder. This is very important, older drivers won’t work,
  1. Make usbfix with same file FG as used with v53.
  1. Try to open sw, if your computer is xp run eobd.exe not eobd2.exe

If win7 run eobd2s.exe.

FGTECH V54 Introduction:
Model name:FGTech Galletto
Firmware Version:V54
Software Version:V4
Car Models:For Multi-cars
Functions:ECU Programmer
Connection:By OBD2.
Computer requirements:XP ONLY

The above installation procedure applies to following fgtech galletto PC board:


  • Best quality V54 FGTech Galletto 4 Master



24hour Online Customer Service:


No Comments

Leave a Reply

Your email address will not be published. Required fields are marked *