Free download Ktag/ Kess V2 software Ksuite v1.93, which can solve:
– error “Tool is not updated”
– ktag/kess not working with gray buttons
Part 1: Kess v2 Ktag v1.93 download on Mega
Working ok with:
SE87-D: V2.28 KESS V2 Firmware V4.036
SE80-B: KTAG Firmware V6.070 KSuite V2.1.3
SE80-D: V2.13 KTAG KTM100 FW V7.003
Suitable for the ktag/kess v2 QC mark ends with numbers“015”
Not suitable for other kess or ktag programmers.
If you try on other version, eobdtool.co.uk hold no responsibility for your try.
Part 2: How to solve Kess v2 error “Tool is not updated”
Here is the error message when running ktag.
kess v2ACHTUNG: Tool ist nicht aktualisiert. PC mit Internet verbinden und Software erneut ausfuhren
(kess v2 CAUTION: Tool is not updated. Connect PC to the Internet and run software again)
Here you go….
Change another laptop / use another USB cable for reflash by J-Link,disconnect internet connection, re-install ksuite software and driver. Run again the Ksuite software.
If it doesn’t work, download ksuite v1.93 above. It will work as usual.
Part 3: How to solve Ksuite not working with gray buttons
Ktag/kess v2 not working with gray buttons after successful ksuite installation
Here you go….
1- cut the folder of kusite (v2.11) and paste it to Desktop
2- install ksuite v1.93 software
3- delete the ksuite folder in disk C:
4- cut the ksuite v2.11 folder on Desktop and paste it to C:
5-KESS V2 Firmware V4.036, KTAG Firmware V6.070, KTAG KTM100 FW V7.003 will work
If all solutions above do not work, you had better send back your ECU programmer for repair.
24hour Online Customer Service: